Cortex VEXnet Bedienerhandbuch PDF herunterladen (Seite 55)

ROBOTC

VEX Cortex Conguration over USB • 8

2011 Carnegie Mellon Robotics Academy / For use with VEX Robotics Systems

VEXnet Joystick Conguration in ROBOTC (cont.)

Section 3: Calibrating the VEXnet Joystick Values

The VEXnet Remote Control includes two joysticks (each having an X and Y-axis), 8 buttons on

the front, and 4 additional trigger buttons on the top. Inside, there is also 3-Axis accelerometer,

capable of providing X-Y-Z acceleration values. Values from the joysticks, buttons, and

accelerometer are sent as a constant stream of information over VEXnet to the robot, enabling a

user to control the robot in real-time.

To ensure that the VEXnet Joystick sends out accurate joystick values, the joysticks must be

calibrated before their rst use, and after any rmware updates are applied.

You will need:

• A VEXnet Joystick with batteries

• A VEX Cortex with robot battery

• A small Allen wrench (1/16” or smaller) or paper clip

This section contains the procedure for calibrating the VEXnet Remote Control joysticks.

Some steps are time-sensitive, so it’s recommended that you read through the instructions once

before following along.

1. Power on the VEXnet Joystick and VEX Cortex. Allow them to sync over VEXnet.

Setup

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 94 95

Keine Kommentare

Cortex VEXnet Bedienerhandbuch Seite 55