Cortex HDTT-5000 Einstellungsanleitung PDF herunterladen (Seite 10)

STEP ONE

Connect the Power Cord to the power outlet., found on the rear of the

unit.

STEP TWO

Connect the RCA audio outputs of the unit to a suitable audio mixer.

When connecting the unit, make sure you note that the MASTER outputs

carry audio from the MASTER or MAIN deck, and SLAVE outputs carry

audio from the SLAVE or AUX deck.

Note: When in SLAVE mode the outputs of the SLAVE unit will not operate

instead all outputs are routed through the MASTER

unit.

STEP THREE

Connect your primary USB device to the port found to the right of

the rear panel. You may choose any driverless device that follows

FAT32, NTFS, or HFS+ file systems. You may also connect a pow-

ered (active) USB hub to augment the amount of available ports.

If you wish to link 2 HDTT-5000s together, select the unit you desire

to be Master, flip the Master/Slave switch to “M”, then power on. Do

the same for the unit that you wish to slave off the unit, only select

“S” on the Slave unit. Connect a standard USB cable to the chain link

OUT port on the MASTER and then to the chain link IN port on the

SLAVE. Then connect the audio outputs for both units to the Master

unit.

STEP FOUR

Press and Hold the Power button located in the center of the front panel

for about 1-2 seconds. The unit will take about 5-10 seconds to boot up

as well as detect any USB devices that are currently connected.

Preparing for Use/Master Slave opperation

Fig 1.1 - Connect Power

Fig 1.2 - Connect Audio

Fig 1.3 - Connect USB

Fig 1.5 - Turn Power ON

HDTT-5000 Operation Manual

CONNECT TO MIXER

MASTER

STANDARD USB CABLE

SLAVE

Fig 1.4 - Master/Slave Connection

SWITCH TO “M”

SWITCH TO “S”

(Not Included)

MSD IN 3

MSD IN 4

SD IN 3

SD IN 4

1 2 ... 5 6 7 8 9 10 11 12 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare

Cortex HDTT-5000 Einstellungsanleitung Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für DJ-Controller Cortex HDTT-5000